Kohout Engineering
CZ EN

Evolution of the Chamber

2012

Development of the second generation of heating panels with unique flexible construction. Each panel is equipped with a set of sensors and its own microprocessor, which is controled by the central control system. This solution allows individual parameters adjustment and monitoring of each book during a drying cycles. Heating panels are protected by three patents.

2011

Development of the next generation hermetically sealed air conditioning system, which extends the chamber's capabilities.

2010

Thermal insulation of the chamber door with special insulating paint "TEPLOMET" to remove unwanted moisture condensation on the internal surface of the chamber door during certain modes of drying in a controlled atmosphere.

2009

Reconstruction and extension of the freezing system, the installation of two new freezers with duplex operation and heat recuperation.

Chamber modification for use in non-oxygen atmosphere, the research of wood-destroying insect control in non-oxygen atmosphere.

2008

Drying of the precious historical drawings from the National technical Museum in Prague, sized 1820 x 1200 mm.

2006

Evaluation of the experimental operation, start of the regular operation,
drying of the saved books that were deposited in cold stores.

2005

Verification of functions, developing and debugging control software, start of the experimental operation.

2004

Parts manufacturing and technology assembling.

2003

Defining technical requirements and design of device, project processing.
Project was presented at the International Conference CASLIN 2003.

2002

High water in Czech Republic.